PDA

View Full Version : [Solved] N900 only powers on with a USB cable

noiseqowo
04-21-2011, 06:26 AM
Hello guys,

I recently acquired a Nokia N900 and i absolutely like the device although i'm experiencing a quite annoying issue.

My Nokia N900 will only cold power on after inserting a USB cable. Otherwise, when the power button is pressed, only the Nokia splash screen is shown and then it turns off, with a yellow LED fading indication.

I already flashed the device, put it in R&D mode, disabled the watchdog timers on the boot, flashed again, but still can't get rid of that annoying thing that is being unable to turn on the phone after turning it off.

Do anyone of you have experienced such thing?

Thank you guys ;- )
fahadj2003
04-21-2011, 07:04 AM
i dunno
charge it?
noiseqowo
04-21-2011, 07:08 AM
Well, no. I tested with two batteries, both fully charged.
retsaw
04-21-2011, 07:41 AM
Have you done a full reflash (eMMC and rootfs)? If you haven't try that, if you have then did you buy it new or second hand? If new, then return it as faulty, if second hand, go to Nokia's site and see if Nokia will do a warranty repair (they base it on their recorded manufacture date for the device if you don't have a receipt).
noiseqowo
04-21-2011, 08:14 AM
Have you done a full reflash (eMMC and rootfs)? If you haven't try that, if you have then did you buy it new or second hand? If new, then return it as faulty, if second hand, go to Nokia's site and see if Nokia will do a warranty repair (they base it on their recorded manufacture date for the device if you don't have a receipt).

Done full reflash some four times. Can it be caused by the BME sub-system?
retsaw
04-21-2011, 08:54 AM
What do you mean by cold power on? Do you mean just turning back on after switching off, or after removing the battery for several minutes?

The difference being is there is normally a minimal system running BME, but it won't be running if you have had the battery out.

Another thing you could try is Cold Flashing (http://wiki.maemo.org/Updating_the_firmware/Cold_Flashing), it is meant for when you have messed up the bootloader so can't flash normally, I'm not sure if it is appropriate for your problem but I can't think what else to suggest other than send it to Nokia to fix.
noiseqowo
04-22-2011, 04:38 AM
Problem solved. Battery was removed for a day and now the system boots normally. It was enough to clear the internal clock settings that led to solving the issue. Thanks.