Thread: Custom Brightness & No Light Sensor (POST #1 & #2)
View Single Post
magic_doc is offline magic_doc
2012-03-01 , 17:47
Posts: 87 | Thanked: 80 times | Joined on Sep 2009
#156
Originally Posted by dr_frost_dk View Post
i use:
Set PWM - Level = 20
Wait - 484,38ms
Set PWM - Level = 0
Wait - 484,38ms
Go To Start

This is not very bright here.
That ist too low for me, I prefer 100 so you can recognize the signal at daylight too.

But yesterday I came accross another problem for the second time now: when I woke up the device, the screen was extremely bright (I suppose max.) for half a second and then settled to the desired brightness.

A killall mce as root didn't solve the problem, only a reboot did.

After the second reboot and trying out your vaulues with LED Pattern editor I found out that this behavoir is triggered by the Pattern Editor.

Do you have any idea about this?

CU Michael