Thread
:
Maemo Leste Playground
View Single Post
suicidal_orange
2020-10-24 , 10:28
Posts: 177 | Thanked: 427 times | Joined on Sep 2017
#
48
Note which way up the port you removed was to find pin 1 then it's basically the same as
this
except instead of soldering to pins on a connector you solder to the pads, the last image in step 2 is the key one.
If you doubt your soldering start with the two pins in the middle and get them perfect - the edge ones can be positioned slightly wider than the pads so are easier (and here you actually want to bridge two pads on one end making it easier still)
A smaller soldering iron tip will help
Quote & Reply
|
The Following User Says Thank You to suicidal_orange For This Useful Post:
juiceme
suicidal_orange
View Public Profile
Send a private message to suicidal_orange
Find all posts by suicidal_orange