View Single Post
Posts: 803 | Thanked: 1,585 times | Joined on Aug 2014
#2
Have to have a think on this, have you held power button down for 10 secs to make sure device is actually off? You would need to put it into R&D mode to flash:
Code:
flasher --enable-rd-mode --set-rd-flags=no-lifeguard-reset
After flashing need to use:
Code:
flasher --disable-rd-mode
P.S. Was in a bit of a hurry this am so will check line of code later
 

The Following 3 Users Say Thank You to aspergerguy For This Useful Post: