hi guys!

I've been following you on this thread for quite some time, and recently also in the chatroom. I'm really impressed by your work so far! Keep it going

I would like to join you in testing, I have a rather good knowledge of linux and also some hardware-level-experience of USB. But I'd still like some advice:

• What would you recommend for checking the device health during testing, i.e. battery voltage/current(in/out)/temperature, VBUS level, etc. What are some interesting procfs/sysfs files to monitor?
• Are there any important I2C registers to monitor? From the bq24150 (0x6b) or other I2C devices?
• To which degree is debugfs and usbmon working in titans new kernel? Any (special) setup needed? (except mounting debugfs and modprobing usbmon)
• Are there datasheets for the TWL4030 and the 1707 (could only find one for TPS65950 which is apparently similar (?) to the TWL)
• And finally: do you know a (working) way to save/restore the whole filesystem in case anything goes wrong?

I think that's it for now… Would be great if you could give me some hints
Btw, it's not important if charging doesn't work, I have a desktop charger.