Thread
:
Fixing USB port, before and after it is to late. (All info in one Thread) (See POST #1)
View Single Post
Tibor Neversink
2012-10-14 , 13:03
Posts: 2 | Thanked: 2 times | Joined on Oct 2012
#
204
Just want to thank everyone on this thread for all the help in securing my USB. I am new to soldering with a hot iron, and with practice, I hope I did a good job (not cold soldered). To make sure I added a little bit of epoxy around the solder. The actual taking the N900 apart was easier then it sounds. Thanks again
Quote & Reply
|
The Following 2 Users Say Thank You to Tibor Neversink For This Useful Post:
dr_frost_dk
,
Estel
Tibor Neversink
View Public Profile
Find all posts by Tibor Neversink