Thread
:
2012 Device Program: Qt 5 Mobile Projects
View Single Post
stuartmarsden
2012-05-30 , 18:51
Posts: 9 | Thanked: 8 times | Joined on May 2012 @ Finland
#
8
I have not developed on Meego before but have been using Qt for years. My proposal would require a third party open source library for it (codec2). This compiles using the usual:
Code:
./configure make make install
Is this easy to do for Meego? I assume I can do the same through the toolchain somehow. For my QtonPi project I was just going to compile on the device as the distros have a full toolchain. I assume an N9 N950 does not have it onboard.
Quote & Reply
|
stuartmarsden
View Public Profile
Send a private message to stuartmarsden
Find all posts by stuartmarsden