View Single Post
Posts: 53 | Thanked: 146 times | Joined on Apr 2012 @ Australia
#2
So, I had another go at getting in, this time with a more expensive torx bit. This time I managed to get the tight screw out without damage.

I have had a search on the internet, but I wondered if anyone had any ideas where to get a replacement receiver from? A few images are attached.

The receiver appears to be held in place with adhesive. As you can see when I tried to bend the springs out a bit one popped right out. Disappointing, but it was practically not working anyway. It measures 6 x 12 mm. Not sure about the depth.

If anyone has any contacts that may be able to source one, please let me know. Happy to pay of course.

Worst case, I may have to start ordering random ones. Not sure where to start though.

Thanks again.

For slightly better quality images click below.
https://drive.google.com/file/d/0Bz0...ew?usp=sharing
https://drive.google.com/file/d/0Bz0...ew?usp=sharing
Attached Images
  
 

The Following 4 Users Say Thank You to juz For This Useful Post: