View Single Post
Posts: 69 | Thanked: 10 times | Joined on Nov 2007
#21
Same problem. Same symptoms. About the time I installed Personal Launcher. Hmm?

Work around: Open sketch. Draw vertical lines near the left and right edges of the drawing area. Observe the offset. The offset on the left was zero. On the right, 1/8 inch. Draw horizontal lines at the top and the bottom of the drawing area. Observe. The top was right on. The bottom offset was 1/16 inch.

Next I launched the calibration software. For point 1, I touched the center of the bullseye. Point 2: 1/8 inch to the right. Point 3: 1/8 inch to the right and 1/16 inch down. Point 4: 1/16 inch down from the center of the bullseye.

After two iterations, I was satisfied with the calibration.

Good luck