You're welcome. Always glad to help a fellow forumer
Please make sure your device is properly powered OFF prior to connecting the USB cable. You can power your device off by holding down the power button for 8+ seconds. Flashing your device will erase all data and reset the device back to factory state. Please make sure you have backups of your data before proceeding with flashing. If flashing does not start disconnect the USB cable from the device, make sure the device is OFF and then reconnect the device with the USB cable. For first flashing you may need to repeat this a few times. Depending on amount of data to be securely erased, the erasing may take as long as 30 minutes until the flashing starts. Please, be patient. Check first that device is powered OFF and then connect USB cable. flasher 3.12.0 (Jun 30 2011) Harmattan Suitable USB interface (bootloader/phonet) not found, waiting... Found device RM-696, hardware revision 1603 NOLO version 2.3.6 Version of 'sw-release': DFL61_HARMATTAN_30.2012.07-1_PR_001 Sending ape-algo image (7096 kB)... 100% (7096 of 7096 kB, avg. 13859 kB/s) Suitable USB interface (phonet) not found, waiting... Ping attempt 1 (250 ms) Server application: 1.7.2 Found product RM-696 rev. 1603 Server implements softupd protocol version 1.8 Image SW version DFL61_HARMATTAN_30.2012.07-1_PR_001 Image moslo not present Image mmc not present Image tar skipped Image config skipped Battery level 60 %, continuing. image [state progress transfer flash speed] --------------------------------------------------------------------- [x] cert-sw [finished 100 % 1 / 1 kB NA ] [x] cmt-2nd [finished 100 % 95 / 95 kB NA ] [x] cmt-algo [finished 100 % 789 / 789 kB NA ] [_] cmt-mcusw [finishing 25 % 6050 / 6050 kB 3316 kB/s] [x] xloader [finished 100 % 23 / 23 kB NA ] [x] secondary [finished 100 % 94 / 94 kB NA ] [x] kernel [finished 100 % 2714 / 2714 kB 2429 kB/s] [_] rootfs [finishing 100 % 32768 / 1163796 kB NA ] ERROR: SU_GET_UPDATE_STATUS_REQ terminated with error code 1: Unknown error image [state progress transfer flash speed] --------------------------------------------------------------------- [x] cert-sw [finished 100 % 1 / 1 kB NA ] [x] cmt-2nd [finished 100 % 95 / 95 kB NA ] [x] cmt-algo [finished 100 % 789 / 789 kB NA ] [x] cmt-mcusw [finished 100 % 6050 / 6050 kB 3316 kB/s] [x] xloader [finished 100 % 23 / 23 kB NA ] [x] secondary [finished 100 % 94 / 94 kB NA ] [x] kernel [finished 100 % 2714 / 2714 kB 2429 kB/s] [f] rootfs [finishing 0 % 32768 / 1163796 kB NA ] Fetching error list: ======================================== bb5_rdc_cert_read failed bb5_rdc_cert_read failed bb5_rdc_cert_read failed bb5_rdc_cert_read failed bb5_rdc_cert_read failed bb5_rdc_cert_read failed mmc: sfdisk returned status 1 mmc: Could not exec 'tune2fs -L rootfs /tmp/sudmmc5pxdxz/internal0p2' mmc: Could not remove mount directory /tmp/sudmmc5pxdxz/mnt: No such file or dir ectory [Pipe 5] Finishing in error state with status 1 ======================================== ERROR: Failed to flash images Press Enter to exit & Unplug the USB cable from the device to boot new flashed i mage ...