Thread: N900 eMMC PR1.2 flash freezes
View Single Post
jaywhy13 is offline jaywhy13
2010-07-02 , 18:01
Posts: 80 | Thanked: 9 times | Joined on Oct 2007
#1
I'm thoroughly confused. I just got my N900 yesterday. It's been running very slowly and I want to do a hard reset. The eMMC flash freezes at the second dot.

Here is what I have done.

Code:
flasher-3.5.exe -F RX-51_2009SE_10.2010.19-1_PR_COMBINED_MR0_ARM -f
Then I held down "u" and plugged it in... that runs through successfully. Then, I unplug the device and run.

Code:
flasher-3.5.exe -F RX-51_2009SE_10.2010.13-2.VANILLA_PR_EMMC_MR0_ARM -f -R
The output is seen below... it gets stuck there. On my device. First it gives the loading screen with the three dots then it eventually gets stuck on the second dot.

Code:
Image 'mmc', size 255947 kB
        Version RX-51_2009SE_10.2010.13-2.VANILLA
Suitable USB device not found, waiting.
USB device found found at bus bus-0, device address \\.\libusb0-0001--0x0421-0x0
105.
Found device RX-51, hardware revision 2101
NOLO version 1.4.14
Version of 'sw-release': RX-51_2009SE_10.2010.19-1_PR_MR0
Booting device into flash mode.
Suitable USB device not found, waiting.
How can I get past this?