View Single Post
peterleinchen's Avatar
Posts: 4,117 | Thanked: 8,901 times | Joined on Aug 2010 @ Ruhrgebiet, Germany
#1161
Originally Posted by impeham View Post
i am trying to recalibrate the N900 to my dual scud battery according to Estel's great guide (http://talk.maemo.org/showpost.php?p...&postcount=846)
For calibrating the dual-scud, just leave your N900 without battery for one night and then fully charge and fully discharge. This worked for me, cause the chip was reset and started from 2056.
Nevertheless shadowjk meant to just check CSOC to reach 100% (normal capacity) and then do not fully charge up, so the capacity jump up is not so extreme.
Charge for about 2 1/2 hours, check CSOC to 100 and then charge a little bit more (less than 1 h). So next discharge will last for a bit more of capacity, but not dual capacity.

Originally Posted by impeham View Post
After VDQ=1 (battery is full) I disconnect the charger and run "stop bme".
Did you stop BME during discharge?
This is not useful, as this was mentioned for using charge script,
But this may be answered better by Estel or shadowjk, _dr_frost_dk_.



Hope this helps.

For me calibrating dual-scud was piece of cake,
But now I can not get my single battery calibrated anymore. I think my problem is not living long enough at end of battery for setting EDV=1 ?
 

The Following User Says Thank You to peterleinchen For This Useful Post: