Im using 1.4 R112 on both my devices. Everytime i get one of these revisions i simply delete everything in the .reaver folder and start again with the contents of new revision.

As ive stated before, on one of my devices it cracks it it but the window closes so fast i cant make out the WPA code and PIN. However thanks to you and Szopin i now have multiple ways of extracting that , the best being that DBbrowser method!

On my other phone the window stays open ? anyway...

I suggest doing this to see isolate where your problem is:

Pre-requisites: have ready the ESSID of the WPS enabled device

1. put on bleeding edge drivers
2. open xterminal
3. gain root
4. put wireless into monitor mode (airmon-ng start wlan0)
5. wait until the message tell you that the card is in monitor mode usually by displaying "mon0" or "mon1" etc....
6. the reaver command i use is this "reaver -i mon0 -b (now enter the ESSID) -vv -N -S -d 0"

tell me what happens during your trial. this way we can see if your reaver implementation is working . if successful, then it could be your installation of Cleven.

you probably have done all the above anyway , im just a noob to this ...

The following routers i have tested on
Netgear (superhub virgin)
Netgear (sky)
Dlink ( sky)
sagem (sky)
normal dlink and netgear routers
Talk Talk routers