View Single Post
Posts: 669 | Thanked: 433 times | Joined on May 2010
#1163
Originally Posted by peterleinchen View Post

Did you stop BME during discharge?
This is not useful, as this was mentioned for using charge script,
But this may be answered better by Estel or shadowjk, _dr_frost_dk_.
Yes - i stopped BME because i cannot get to less than 3250mv with it set to on, so i charge when BME is on, and after i disconnect the charger (after VDQ=1) i run "stop bme" and continue the described process for discharge.

Is this process wrong?

One more question for something i didn't understand - does it matter how i charge? for example - can i charge during backupmenu creating a backup, reboot (but not getting to a full charge where VDQ should become 1) and continue the process i described above?

Is there a reason to do the charge with the charge script instead of BME?

dr_frost_dk - from the schematic i see in the 2nd post, i don't understand why there are connections to the cover. soldering a wire between + and +, - and - of the two batteries is not the only thing needed?

Last edited by impeham; 2012-02-21 at 23:36.