Originally Posted by michaaa62

The partition table looks fine.

Did you apply the file system to the partition via command line, a remote PC or the maemo HildonFileManager?

Edit: A quick search did not reveal any solution, but to apply a fresh new file system to the partition
Is that a viable solution for you?

Originally Posted by rajanmb2005

BusyBox v1.10.2 (Debian 3:1.10.2.legal-1osso30+0m5) built-in shell (ash)
Enter 'help' for a list of built-in commands.

~ $ sudo gainroot
Root shell enabled


BusyBox v1.10.2 (Debian 3:1.10.2.legal-1osso30+0m5) built-in shell (ash)
Enter 'help' for a list of built-in commands.

/home/user # echo "unit: sectors
> /dev/mmcblk0p1 : start= 64, size= 51199936, Id=c
> /dev/mmcblk0p2 : start= 56631360, size= 4194304, Id=83
> /dev/mmcblk0p3 : start= 60825664, size= 1572864, Id=82
> /dev/mmcblk0p4 : start= 51200000, size= 5431360, Id= 5" > table
/home/user # sfdisk --no-reread /dev/mmcblk0 < table

Disk /dev/mmcblk0: 977024 cylinders, 4 heads, 16 sectors/track
Old situation:
Units = cylinders of 32768 bytes, blocks of 1024 bytes, counting from 0

Device Boot Start End #cyls #blocks Id System
/dev/mmcblk0p1 1 1 1 32 83 Linux
/dev/mmcblk0p2 884865 950400 65536 2097152 83 Linux
/dev/mmcblk0p3 950401 974976 24576 786432 82 Linux swap / Solaris
/dev/mmcblk0p4 800000 884864 84865 2715680 5 Extended
New situation:
Units = sectors of 512 bytes, counting from 0

Device Boot Start End #sectors Id System
/dev/mmcblk0p1 64 51199999 51199936 c W95 FAT32 (LBA)
/dev/mmcblk0p2 56631360 60825663 4194304 83 Linux
/dev/mmcblk0p3 60825664 62398527 1572864 82 Linux swap / Solaris
/dev/mmcblk0p4 51200000 56631359 5431360 5 Extended
Warning: no primary partition is marked bootable (active)
This does not matter for LILO, but the DOS MBR will not boot this disk.
Successfully wrote the new partition table

Re-reading the partition table ...
BLKRRPART: Device or resource busy
The command to re-read the partition table failed
Reboot your system now, before using mkfs

If you created or changed a DOS partition, /dev/foo7, say, then use dd(1)
to zero the first 512 bytes: dd if=/dev/zero of=/dev/foo7 bs=512 count=1
(See fdisk(8).)
/home/user #