View Single Post
Posts: 1,224 | Thanked: 1,763 times | Joined on Jul 2007
#15
Originally Posted by MohammadAG View Post
And.. a new bug, if you connect the wall charger to the device, 100% of the time it will stay on 500 (sometimes 550?) MHz, we do not know the behavior of an overclocked device when this bug is triggered on it, if it stays clocked @ 900 (for example), then we're going to see some dead devices pretty soon.
Power kernel + PR1.3 behaves in exactly the same as stock PR1.3: minimum freq is set to 500MHz, and ondemand governor changes between this frequency and maximum frequency as appropriate.

Even if it was locking the minimum frequency to 900 MHz, we were not going to see some dead devices pretty soon, so I will thank you if you stop spreading FUD, especially as the modifications you work on a, and announce proudly in this thread, are a lot more dangerous to people's devices.

Stupid Moderator EDIT: I was requested to state some facts on this topic. I did no further investigation as I trust my sources. PR1.2 Titan Kernel does not behave as the PR1.3 Kernel and does not make the CPU sticking at 500MHz while on wall-charger. PR1.3 hostmode Kernel has the same problem like stock Kernel as the patches have been applied to it as well. Hostmode modifications are not recognized to harm hardware yet (and I doubt there will be proof of the statement above).

(Side-note: some 1.2 stock hickup had the device stuck at 500MHz while connected to usb, but there you get a msg that your device wont charge at this port)

Dear stupid moderator: Why did you choose to edit my post in order to state this fact that "PR1.2 Titan Kernel does not behave as the PR1.3 Kernel ", what is the relevance of this?

What I wrote is that Power kernel + PR1.3 patches behaves exactly as PR1.3 kernel in this regard: When connected to USB (whether charger or host) - the minimum frequency is set to 500MHz. I write this in response to MohammadAG's (unbased) comment that it is possible that power kernel might set the minimum frequency to 900 MHz. I really don't see how you can misunderstand my statement.

As I like to edit your signature but should not do so...
Dear honest, super intelligent and delightful Member
Power kernel + PR1.3 patches != Power kernel + PR1.3 behaves
And I did not misunderstand it, but for average Joe this is misleading!
You write like you want to attack someone and you just did! Instead you could have edited your post and behave like a grown up, you want this in public... go ahead, you want this in private... don't call me edit insane!
__________________
My repository

"N900 community support for the MeeGo-Harmattan" Is the new "Mer is Fremantle for N810".

No more Nokia devices for me.

Last edited by chemist; 2010-11-09 at 17:00.
 

The Following 6 Users Say Thank You to Matan For This Useful Post: