View Single Post
Texrat's Avatar
Posts: 11,700 | Thanked: 10,045 times | Joined on Jun 2006 @ North Texas, USA
#121
For those unwilling to solder but don't mind disassembling, as I've said before epoxy should work if the surfaces are clean and it's applied properly. I would investigate epoxy types first though.

For those unwilling to disassemble, it's *possible* to apply epoxy without doing so but very tricky and no guarantee you would hit the right spots. There are needle dispensers available, some in very small diameters, and I would recommend considering that if you go the epoxy route (even if you disassemble).

EDIT: I see that dr frost touched on this at the start of the tread. Nicely done.
__________________
Nokia Developer Champion
Different <> Wrong | Listen - Judgment = Progress | People + Trust = Success
My personal site: http://texrat.net
 

The Following User Says Thank You to Texrat For This Useful Post: