I have tried to use N900 as WiFi USB Server for a Windows Client but it not works.

• On N900 (Power Kernel v48) I have done:
  • Used h-e-n to power and enumerate an Usb Stick (full usb 2.0)
  • Connected N900 to Access Point
  • Loaded the needed usbip modules and started the usbip deamon:
    sudo gainroot
    modprobe usbip
    modprobe usbip_common_mod
    usbipd -D
  • Shared the Usb Stick:
    usbip_bind_driver --usbip 1-1
• On Windows (Seven x64 with UsbIp driver installed) I have done:
  • Listed remote usb device:
    C:\Users\xxxx\usbip_windows_v0.2.0.0_signed>usbip -l 192.168.x.3
    This works correctly and reports:
    - 192.168.x.3
    1-1: SanDisk Corp. : Cruzer Micro 256/512MB Flash Drive (0781:5151)
    : /sys/devices/platform/musb_hdrc/usb1/1-1
    : (Defined at Interface level) (00/00/00)
    : 0 - Mass Storage / SCSI / Bulk (Zip) (08/06/50)
  • Attached the remote usb device:
    C:\Users\xxxx\usbip_windows_v0.2.0.0_signed>usbip -a 192.168.x.3 1-1
    This not works, it hangs for some seconds and then it returns an error:
    new usb device attached to usbvbus port 1
    usbip err: usbip_windows.c: 374 (write_to_dev) read from sock ret 0 not equal a usbip_header
    

After the error something crashes on N900 because there isn't anymore shared usb device and the command lsusb hangs if executed.
I must reboot N900 to fix it

I have tried 2 o 3 times with different Usb devices, with always same results (and crashes)