Thread
:
Touchscreen calibration not right
View Single Post
oldmancoyote1
2008-11-24 , 03:33
Posts: 69 | Thanked: 10 times | Joined on Nov 2007
#
21
Same problem. Same symptoms. About the time I installed Personal Launcher. Hmm?
Work around: Open sketch. Draw vertical lines near the left and right edges of the drawing area. Observe the offset. The offset on the left was zero. On the right, 1/8 inch. Draw horizontal lines at the top and the bottom of the drawing area. Observe. The top was right on. The bottom offset was 1/16 inch.
Next I launched the calibration software. For point 1, I touched the center of the bullseye. Point 2: 1/8 inch to the right. Point 3: 1/8 inch to the right and 1/16 inch down. Point 4: 1/16 inch down from the center of the bullseye.
After two iterations, I was satisfied with the calibration.
Good luck
Quote & Reply
|
oldmancoyote1
View Public Profile
Send a private message to oldmancoyote1
Find all posts by oldmancoyote1