Thread: N900 eMMC PR1.2 flash freezes
View Single Post
MohammadAG's Avatar
MohammadAG is offline MohammadAG
2010-07-02 , 19:25
Posts: 2,473 | Thanked: 12,265 times | Joined on Oct 2009 @ Jerusalem, PS/IL
#4
Originally Posted by jaywhy13 View Post
I'm thoroughly confused. I just got my N900 yesterday. It's been running very slowly and I want to do a hard reset. The eMMC flash freezes at the second dot.

Here is what I have done.

Code:
flasher-3.5.exe -F RX-51_2009SE_10.2010.19-1_PR_COMBINED_MR0_ARM -f
Then I held down "u" and plugged it in... that runs through successfully. Then, I unplug the device and run.

Code:
flasher-3.5.exe -F RX-51_2009SE_10.2010.13-2.VANILLA_PR_EMMC_MR0_ARM -f -R
The output is seen below... it gets stuck there. On my device. First it gives the loading screen with the three dots then it eventually gets stuck on the second dot.

How can I get past this?
Reflash the fiasco again, then run the eMMC command, do not boot up the device in between (unplugging it causes it to boot).
So basically, run first command, second command, then unplug it if you wish.