Thread
:
Fixing USB port, before and after it is to late. (All info in one Thread) (See POST #1)
View Single Post
Texrat
2012-04-14 , 00:21
Posts: 11,700 | Thanked: 10,045 times | Joined on Jun 2006 @ North Texas, USA
#
121
For those unwilling to solder but don't mind disassembling, as I've said before epoxy should work if the surfaces are clean and it's applied properly. I would investigate epoxy types first though.
For those unwilling to disassemble, it's *possible* to apply epoxy without doing so but very tricky and no guarantee you would hit the right spots. There are needle dispensers available, some in very small diameters, and I would recommend considering that if you go the epoxy route (even if you disassemble).
EDIT: I see that dr frost touched on this at the start of the tread. Nicely done.
__________________
Nokia Developer Champion
Different <> Wrong
|
Listen - Judgment = Progress
|
People + Trust = Success
My personal site:
http://texrat.net
Quote & Reply
|
The Following User Says Thank You to Texrat For This Useful Post:
Estel
Texrat
View Public Profile
Send a private message to Texrat
Visit Texrat's homepage!
Find all posts by Texrat