View Single Post
Posts: 34 | Thanked: 17 times | Joined on Jun 2010 @ India
#29
since this is a for-beginner's thread:

if on flashing an error comes up like this (full error below) (and my n810 showed a usb sign in a corner and stayed there)

Flashing initfs... Sending request 0x50 failed: Operation timed out

Code:
USB device found found at bus 004, device address 003-0421-0105-02-00.
Found device RX-44, hardware revision 0805
NOLO version 1.1.11
Version of 'sw-release': RX-44_2008SE_2.2007.51-3_PR_MR0
Sending xloader image (9 kB)...
100% (9 of 9 kB, avg. 3000 kB/s)
Sending secondary image (98 kB)...
100% (98 of 98 kB, avg. 14053 kB/s)
Flashing bootloader... done.
Sending kernel image (1500 kB)...
100% (1500 of 1500 kB, avg. 11455 kB/s)
Flashing kernel... done.
Sending initfs image (2273 kB)...
100% (2273 of 2273 kB, avg. 23196 kB/s)
Flashing initfs... Sending request 0x50 failed: Operation timed out
Without disconnecting or otherwise disturbing the n810, I just reran the flasher command as previous.
This allowed flasher to continue on and complete and then the n810 reboots.
Dont know what would have happened if i had disconnected at the point of error.

fyi, i was flashing the n810 on a mac.