View Single Post
Posts: 32 | Thanked: 94 times | Joined on Jun 2012
#6
Since, according to the same post, DIY doesn't need to solder anything, I assume the assembly doesn't need any component which is soldered to the main board, so for me it's pretty clear.

However, I wonder how every piece can be re-used while increasing the size of the device by 2.8mm. I thought at least some piece of the case were supposed to be replaced (and so, maybe some screws too).

Can anyone enlight us on this point ?
 

The Following 3 Users Say Thank You to Bearserker For This Useful Post: