Thread: Game Pad ~ Multi Accessory Case Work Log
View Single Post
andrewfblack's Avatar
andrewfblack is offline andrewfblack
2008-06-16 , 14:42
Posts: 1,656 | Thanked: 1,196 times | Joined on Apr 2008 @ Alabama, USA
#5
Originally Posted by fredoll View Post
Nice project Andrew,
How do you plan to plug you gamepad into the NIT ?
I suppose you'll have to unmount the stand ?
And will you take the buttons and pads from a USB gamepad ?
The buttons and pads are going to be stripped out of the gamepad. Then run through the USB hub into the tablet. I wont unmount the stand I'm going to have a slot in the top of the case you unfold the stand and it will insert into the case. I haven’t measured how long the stand sticks out from the tablets but I don't think it sticks out more then 1.7 inches. As far as plugging in the hub I havn't decided yet I could either have little bit of the wire and plug sticking out or I can kinda mount the plug on the front of the case and have you kinda slide the tablet onto the plug.
__________________
Home Page - Preenv Wiki

**All Posts are made as a Community Member and not as a Super Moderator of this site.
Last edited by andrewfblack; 2008-06-16 at 14:44.