View Single Post
Posts: 518 | Thanked: 160 times | Joined on Dec 2009
#22
I think the bigger issue is not so much the entire receptacle coming off the circuit board, but the USB contact points disconnecting. It didn't seem to take much, given that the contact points are not welded, but "glued" to the board. I'd fear those coming lose before the entire assembly.

Either way, the snug nature of the power plug and port, make sure it "straight-in-straight-out"...there is little "wiggle" room, pun intended. I will concede that mine was an isolated incident, if others can confirm whether or not the power plug is a "tight fit".