Thread
:
Fixing USB port, before and after it is to late. (All info in one Thread) (See POST #1)
View Single Post
dr_frost_dk
2011-08-25 , 10:47
Posts: 1,503 | Thanked: 2,688 times | Joined on Oct 2010 @ Denmark
#
17
Originally Posted by
gregoranderson
Wonko's Powermat mod is well worth following too:
http://talk.maemo.org/showthread.php?t=72753
The power mat takes care of charging, but not USB data (in case of broken USB), you can glue the USB down, it works like soldering down
Solder down:
- pros
REALLY gives all the strength to the USB by having a massive "support" that goes down to the giant GROUND copper around it
- cons
You have to scrape of some paint (not dangerous, really hard to mess up)
You have to apply a lot of heat the the USB casing to insure that the solder is not 'cold' soldered, rendering it useless
Glue down: (2 component glue)
- pros
If cleaned around the USB (where soldered would be used in the solder mod) then this should by all accounts give the same strength as the solder down
- cons
If not
very
careful where the glue is applied, and notice is taken for glue running (since it is a "liquid"), if it gets inside the USB then well your worse for where, you wont be able to use that USB ever again.
__________________
N900 @ 850MHz (LV) & 3044mAh Battery
Battery Tests and Battery Mod / Homemade 3000mAh XL Battery
- (
DONATE
)
Custom Brightness & No Light Sensor
N900 DIY Micro Amplifier, turn your N900 into a home stereo
Fix you USB before and after it breaks
Feel free to contact me through PM, Skype or G.Talk
Quote & Reply
|
dr_frost_dk
View Public Profile
Send a private message to dr_frost_dk
Visit dr_frost_dk's homepage!
Find all posts by dr_frost_dk