Active Topics

 



Notices


Reply
Thread Tools
mike727's Avatar
Posts: 61 | Thanked: 119 times | Joined on Aug 2015 @ Australia
#1
The slider gets stiff on the right-hand side when near the closed position. It will only align up closed when enough force is applied; and it springs slightly open (but it still requires force when opening, during the first inch of travel).

I removed 4 screws to separate the screen. Sliding the screen's inside metal plate, I can't see any obstruction. Removing the screen's bezel & plastic surround seemed to be a way to get better access to the slide's rails.
At first I was trying to pry the plastic off, which started to break. Then I just removed the metal bezel.




Can the remaining plastic surround be removed? (Should it be removed?)
What is a likely cause for the sliding mechanism to get stiff?

(only just purchased the phone, so can only speculate about it's history)

Last edited by mike727; 2017-09-20 at 11:01.
 

The Following User Says Thank You to mike727 For This Useful Post:
Posts: 16 | Thanked: 13 times | Joined on Aug 2010 @ Chicago, Illinois, USA
#2
I've not done anything like this so I don't have an answer, but get a service manual and that might help answer your question.
the two I have are called:
Nokia_N900_RX-51_Service_Manual_Service_Level_1_2
Nokia_N900_RX-51_Service_Manual_Service_Level_3_4
Search for them online.
 

The Following User Says Thank You to bradvesp For This Useful Post:
Reply

Tags
mechanism, rails, slider, sliding, tracks

Thread Tools

 
Forum Jump


All times are GMT. The time now is 02:13.