Thread Tools
mike727's Avatar
Posts: 59 | Thanked: 113 times | Joined on Aug 2015 @ Australia
The slider gets stiff on the right-hand side when near the closed position. It will only align up closed when enough force is applied; and it springs slightly open (but it still requires force when opening, during the first inch of travel).

I removed 4 screws to separate the screen. Sliding the screen's inside metal plate, I can't see any obstruction. Removing the screen's bezel & plastic surround seemed to be a way to get better access to the slide's rails.
At first I was trying to pry the plastic off, which started to break. Then I just removed the metal bezel.

Can the remaining plastic surround be removed? (Should it be removed?)
What is a likely cause for the sliding mechanism to get stiff?

(only just purchased the phone, so can only speculate about it's history)

Last edited by mike727; 2017-09-20 at 11:01.

The Following User Says Thank You to mike727 For This Useful Post:
Posts: 16 | Thanked: 13 times | Joined on Aug 2010 @ Chicago, Illinois, USA
I've not done anything like this so I don't have an answer, but get a service manual and that might help answer your question.
the two I have are called:
Search for them online.

The Following User Says Thank You to bradvesp For This Useful Post:

mechanism, rails, slider, sliding, tracks

Thread Tools

Forum Jump

All times are GMT. The time now is 17:05.