u need to install flasher program as usual on ur computer ( remember that u need to have win xp or vista or 7 32 bit not 64 bit )
after installation , copy custom emmc file and firmware file to this path on ur computer
C:\Program Files\maemo\flasher-3.5
now we have to flash the mobile and it's very simple
follow my instructions and don't change anything
1 - press on start button then all programs then maemo then maemo flasher 3.5 and press on it and u will see dos page
2 - make sure that ur mobile is disconnected from computer and closed
3 - write the following in the dos page :
Code:
flasher-3.5.exe -F EMMC_By.MiDO.FaYad.8.giga.bin -fu will see usb device not found , waiting on the dos page
after that , close ur mobile and press on p button and connect the usb cable while u still press on p then u will see that computer began to see ur mobile and flahing it
4 - after it finish , discoonect ur mobile from computer and remove the battery and insert it again and write this command in dos page to flash the firmware
Code:
flasher-3.5.exe -F xxxx -f -Rand replace xxxx bu ur firmware pr 1.3 name
and press on p and connect the cable while u still press on p and wait untill ur mobile opened
I did everything as it says here, but when I enter:
bassically nothing happens, there is just a cmd window popping out
but it closes very fast...what does this mean, did I flash the firmware as well or? should I try to turn on my device or?
flasher-3.5.exe -F RX-51_2009SE_20.2010.36-2_PR_COMBINED_MR0_ARM.bin -f -Rand
bassically nothing happens, there is just a cmd window popping out
but it closes very fast...what does this mean, did I flash the firmware as well or? should I try to turn on my device or?