So i've tried to install the "NITdroid" and it seems it went bad, i can't start Maemo anymore, i can't even start the NITdroid.

When i turn on the phone the Uboot pops out and one message pops out "press any key to stop the autoboot" i press and nothing happens, the phone turns off, when i let kernel to read it says unable to read boot.scr from mmc and ulimage something like that and after that phone turns off.

When i try to plug it in wall charger the phone turns on by itself, when i try to connect USB same story...

What to do?

You`re in for a read and treat...

http://wiki.maemo.org/Updating_the_tablet_firmware

Be aware that you need a reasonably full battery in order to be able to reflash your phone.


Good luck!

what was the brick part of the problem then?

I don't know how to call this problem so i just said brick...
My phone turns on...everything is okay, but i can't start the Maemo or Nitdroid, and when i try USB connection, the usb icon in the top left corner shows up but only for a 2sec or 3.

Then the penguin shows up "uboot" etc...

By the way, when i plug in the charger it starts to charge but the phone turns on by itself and turns off by itself, the phone turns on when i plug in the charger or USB cable, the phone turns on without any backlight on the screen, i see Nokia logo for 1 second and then i see uboot. So i'm asking how can i repair this, should i buy the memory card reader and format or...? I currently see no way out.
I'll let it charge for a while then i'll see if something can be done. PC does sign the phone has been connected too.

Sorry for bad english.

Also phone turns off when uboot says "starting kernel..."
could it be the battery?

If you fail your phone, just follow this http://discussions.europe.nokia.com/...ta/m-p/591877#

Okay i got flasher working but i didn't manage to connect phone with computer, the usb icon in the top left corner does SHOW UP but only for a second untill it dissapears.

Guys any suggestions?

flash with PR1.3 kernel
If you want NITDroid install multiboot instead uboot

cd "%ProgramFiles%\maemo\flasher-3.5"
then
flasher-3.5.exe -F RX-51_2009SE_2.2009.51-1_PR_COMBINED_MR0_ARM.bin -f -R

then plug the cable in... when you will run the last command it will show in cmd "waiting for device". as the usb shows in the corner it will automatically run it without any distruptions
its easy thats how i always do it
second command - the file name may be different to yours.

But how?! I can't load Maemo or Nitdroid, in fact i can't load any OS, i can't connect USB...