Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

Anyone able to use this program with a TM506?

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

I have the same problem (ie can't dial but can send SMS) with my C902.
But I suppose we'll have to wait for gnokii to support them ...
I use model AT and RFComm 2

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

Ok, I have a HTC Touch Pro with wm 6.1.

I am not having any luck. I read somewhere that this software only supports Nokia phones and that other phones would be add later.

Is my phone supported?

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

Your phone is supported IF it is supported by gnokii ...
You might try the AT model and find out the rfcomm port by trial and error or sdp-tool
There was a wiki page about supported phones but I can't seem ti find it anymore since the move to t.m.o ...
Fred

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

yes i was on the wiki site, i don't see where my device is supportted or not.

as far as trail and error < tried that.

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

I saw that some windowsMobile phone are supported via AT on gnokii Wiki ...

in gnokii-gconf
is your phone's Mac Address filled ?
choose model AT
set rfcomm to 1
save
try phonelink
if it doesn't work
change rfcomm to 2 and try again ...

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

WORKED!!

Thanks....am sending sms but nothing is happening.
But I could see where my phone and tablet are communicating.

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

I'm having trouble getting it to work on my Samsung SCH-U900 (Flipshot), on Verizon. If anybody has any ideas, it would be grealty appreciated.

Using rfcomm 8 I can get it to see my phone. The problem with this is that whenever I make a call, it shows up as a data call (Modem @ 14.4k is what it shows, with Tx and Rx, and total bit/byte information). Then when I use to send an SMS, it does not send to the recipient.

rfcomm 3 and 4 make the phone say "Bluetooth Audio Device disconnected" and the N810 says "unknown error, well better than nothing!"

Thanks in advance.

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

could it be that verizon have messed around with the firmware?

i kinda recall reading that they had done such a thing before on some other phone to stop bluetooth file transfers...

Re: [ANNOUNCE] phonelink 1.4 : Dial Pad
 

Well I know for a fact I cannot send pictures via bluetooth to an AT&T phone, which can accept pictures via bluetooth (her phone is a sony erricson, and she was using bluetooth to send and receive pictures earlier yesterday).

Wouldn't surprise me if verizon did something of the sort but I'm just looking for help :P