Re: LED Pattern Editor by Philipp Zabel
 

Thanks for the feedback.

Do you mean that if you remove the "Set PWM = 0" command from a pattern, testing doesn't work anymore? I can't reproduce that.

Maybe adding some kind of always-on "PatternInhibit" with highest priority could keep mce busy, sidestepping all those race condition issues with the "Test" button.

Re: LED Pattern Editor by Philipp Zabel
 

I noticed this, when i accidentally forgot the "Set PWN" with Level=0 at the beginning of engine2 (which waits for a trigger from engine1). I wasn't able to test the pattern in the app, but the pattern was working anyway.

Similar issue, when i forgot the "Return to start" at the end of engine2: The pattern was working, but the app returned an error code.

Interrupts of testing were noticed, when engine1 is still on and engine2 comes in. when plugged to usb, testing is interrupted immediatelly.

Just noticed that sometimes testing is only possible, when edited before and clicked on done already (may because of manual edit).

Re: LED Pattern Editor by Philipp Zabel
 

if one receives a sms and a missed call the phone only displays the set colour of one of the notification lights, could led pattern (in the next update) be improved to enable the option that the set lights of both the sms and the missed call are displayed/blinked?

Re: LED Pattern Editor by Philipp Zabel
 

I would acctualy like to combine the colors white and blue but this is impossible since white uses all the colors right?

Re: LED Pattern Editor by Philipp Zabel
 

the message that is desplayed before saving "if you get this wrong your phone is dead" how series can this be? I don't wana brick my phone, if I can "test" the pattern and it shows working then am I ok?

I had a look on the wiki but there wasn't much info about it... Any tips on what not to do would be greatfull ;)

Re: LED Pattern Editor by Philipp Zabel
 

You can set one channel to blue and one to yellow (red+green). Light up blue+yellow at the same time to get white. Try pasting the following pattern for a start:
In theory, the worst case scenario would be a bug in the LED pattern editor where it writes a broken mce.ini that causes a mce startup failure (and thus possibly reboot loop).
In practice, I've been careful to abort early enough if there are inconsistencies. By now, the program has been tested by quite a few people, and so far nobody has been able to make it fail (and lived to tell about it). I should just remove that warning instead of needlessly scaring people.

Re: LED Pattern Editor by Philipp Zabel
 

The first time the message did scare me, I found that on some occasions when using the test button that the led would not do exactly what was on the screen so when I then went to save I was orried I had done something wrong, for the moment I have just changed the colours, as some kinds of message are more important than others (im is red as they need a faster reply)

Re: LED Pattern Editor by Philipp Zabel
 

i have changed the color of "PowerOn" but the color is still white when im turning on the device......

im i doing something worng?

Re: LED Pattern Editor by Philipp Zabel
 

****bump****

Re: LED Pattern Editor by Philipp Zabel
 

http://talk.maemo.org/showthread.php...425#post650425

I don't think it is possible to change it.