Re: After flash, no more vibration
 

thats a bit odd, was my assumption qt came on the devices..... hmmmmmm will look into it.

Re: After flash, no more vibration
 

Disable extras-devel if it's enabled.

Re: After flash, no more vibration
 

Does it hum shortly when being powered up?

A standard N900 will hum on boot. When off, hold down the power button. While LED will fill up and when it's done and the device starts to boot, a short vibration should take place on all configurations.

This is regardless of settings and MCE service. If it doesn't, it's likely stuck/broken.

Re: After flash, no more vibration
 

Disabling extras-devel helped to install.

Now i have made a vibration test.

But then i can hear three times a quiet sound but no vibration :'-(

Re: After flash, no more vibration
 

I had that problem on day 2.
A month or two later I connected it to the charger and ran this in terminal (will activate the motor with the same pattern as an incoming call.
The next day it was working.
Keep in mind that it might not work for you, but it's worth a shot.

Edit: If that doesn't work I suggest taking it to a Nokia Care Center.

Re: After flash, no more vibration
 

o, thats what hc calls.

Re: After flash, no more vibration
 

i think i have to go to a nokia care center

nothing helps :(

everytime only the same sounds

do you think that i have to delete the programms and repositories ???

Re: After flash, no more vibration
 

I forgot to say I left it vibrating over night
(before some smart*** decides to make a joke I left it on a desk in the other room)

@ OP it's a hardware problem, either something is in the vibration motor or it's completely dead.

Re: After flash, no more vibration
 

better let him know the deactivate command for the morning :)

Re: After flash, no more vibration
 

Oops