Minimum Frequency won't stay?
 

Can anyone tell why when i change the min frequency to say.. 250Mhz it changes itself back to 125Mhz? I'm using Enhanced Linux Power Kernel 2.6.28.10 on pr1.2
Thanks in advance
Nath

Re: Minimum Frequency won't stay?
 

was it before configured to 125mhz???
try this:
load the profile first and then set up your limits
root
kernel-config load lv (for example)
kernel-config limits 250 900 (for example)
and so on

Re: Minimum Frequency won't stay?
 

After reboot i...
kernel-config limits 500 1000
kernel-config show then shows min500 max1000
but after a short period of runtime (no particular time)
kernel-config show then shows min125 max1000?
I've tried the avoid frequency code but no different.
Any ideas?

Re: Minimum Frequency won't stay?
 

which profile are you using?

Re: Minimum Frequency won't stay?
 

guess i am not only one with same problem....

Re: Minimum Frequency won't stay?
 

I cant even get the kernel to load, when i install and reboot the phone, and goto terminal and after root access type 'kernel-config load lv' it says that the kernal-omap1 not supported and further informs that if i just installed the power kernel i need to reboot to load it, tried many times but no luck!!

Re: Minimum Frequency won't stay?
 

should it better be adjusted on 125mhz or 250mhz??

Re: Minimum Frequency won't stay?
 

So for me the kernel worked just now when i tried it, but i have the same problem as you...the min freq changes to 125 from 250 after a few mins!!!! Why???

Re: Minimum Frequency won't stay?
 

maybe some of you guys tell us which freqs you are using?????????????????????

Re: Minimum Frequency won't stay?
 

try this:

• open X-Terminal
• type sudo gainroot to become root (you need rootsh to be installed for this)
• then type apt-get install --reinstall -y kernel-power kernel-power-flasher
• and after flashing is done reboot the device.

Once you reboot the OS, you can go to X-Terminal and type uname -r. If the version shown contains "power" in it then it means that you've successfully reinstalled the Power Kernel. If not, repeat the steps listed above.

regards