Thread
:
Alternative stylus for N900?
View Single Post
Wikiwide
2019-03-22 , 04:42
Posts: 1,994 | Thanked: 3,342 times | Joined on Jun 2010 @ N900: Battery low. N950: torx 4 re-used once and fine; SIM port torn apart
#
29
Did vacuum moulding and injection moulding at local makerspace. Vacuum moulding with HDPE plastic (milk bottle), heated till it's transparent (and very stretchable) and thrown over the target object (Nokia N900 stylus melted slightly, at the tip, but still works).
They do not have a good 3D scanner, though - and I should go through 3D printing induction (they changed 3D printers, again).
Attached Images
Quote & Reply
|
The Following 9 Users Say Thank You to Wikiwide For This Useful Post:
DA5
,
imaginaryenemy
,
juiceme
,
justmemory
,
Macros
,
Maemish
,
peterleinchen
,
pichlo
,
theonelaw
Wikiwide
View Public Profile
Send a private message to Wikiwide
Find all posts by Wikiwide