|
2012-04-13
, 05:00
|
Posts: 195 |
Thanked: 108 times |
Joined on Feb 2010
@ SF Bay Area, United States
|
#12
|
Hi,
This is a cool app. Thanks a lot. I created a rule which says for numbers starting with +44, use access number xxx-yyx-zzzz . But, I also noticed that it creates entries for numbers not starting with +44 , for eg I have lots of local numbers stored which are like 408-xxx-zzzz, and it shows an option to call these with ViCar. Is it possible to make it show the option only for numbers with +44 in the beginning ie international numbers ?
|
2012-04-13
, 05:11
|
Posts: 195 |
Thanked: 108 times |
Joined on Feb 2010
@ SF Bay Area, United States
|
#13
|
Great app. Very useful!
Just some questions: I don't see on how do configure the pause before sending the DTMF tones? In my case it seems the tones are sent to early, so they are not detected correctly. Where are the VICaR settings stored? Is it possible to play the DTMF tones faster?
Thanks
|
2012-04-13
, 05:37
|
Posts: 59 |
Thanked: 36 times |
Joined on Nov 2009
|
#14
|
On the home screen view you should see an icon for Vicar. Open the application and edit the rule(s) for the numbers you are dialing. In the "Send this tone before dialing:" field, type a "p" without quotes for adding a pause.
The Following User Says Thank You to alex25 For This Useful Post: | ||
|
2012-08-18
, 12:12
|
Posts: 59 |
Thanked: 36 times |
Joined on Nov 2009
|
#15
|
|
2012-08-18
, 17:04
|
Posts: 195 |
Thanked: 108 times |
Joined on Feb 2010
@ SF Bay Area, United States
|
#16
|
I successfully used the VICar app for several months. Now Nokia had to replace my device because of a hardware failure. So I had to reinstall the app.
The problem is now that the app does not detect the other party (the call router) answering the call. The dial tones are never sent. I found out that the dial tones are sent as soon as I put the call on hold and take it back. So it seems that the initial "answering message" (answering the call) is not catched correctly.
The rest works as expected: Intercepting the original call and dialing the number of the call router.
Anybody else with this problem? Is there a way to debug?
(I use firmware 1.3, same as before)
$killall vicar-daemon $/opt/vicar/bin/vicar-daemon > vicar.log& $dbus-monitor --system > dbuslog.txt
Just some questions: I don't see on how do configure the pause before sending the DTMF tones? In my case it seems the tones are sent to early, so they are not detected correctly. Where are the VICaR settings stored? Is it possible to play the DTMF tones faster?
Thanks