so i flashed it with the emmc for now and after the flash it is still stuck on the second dot and hace a solid (orangeish, greenish, whiteish) led. Should i reboot it or install the fiasco
Flashed the eMMC first and the fiasco after, it did not change anything.
I found a log on a diffirent forum that look exactly like mine The guy also had that same problem as me but there were no answers under his post he also done all the flashing and the phone was still that same.
Here are the logs:
Nothing to do!
Usage: flasher [OPTIONS]
Options:
-F, --fiasco=ARG Location of a FIASCO image
-k, --kernel=ARG Location of kernel image
-n, --initfs=ARG Location of initfs image
-r, --rootfs=ARG Location of root JFFS2 image
--cmt-2nd=ARG Location of CMT FIASCO 2nd image
--cmt-algo=ARG Location of CMT FIASCO algorithm image
--cmt-mcusw=ARG Location of CMT FIASCO MCUSW image
--cmt-no-verify Disable verification of CMT programming
-x, --xloader=ARG Location of X-Loader image
-s, --secondary=ARG Location of NOLO secondary bootloader image
-2, --2nd=ARG Location of NOLO cold flasher ("2nd") image
-u, --unpack[=ARG] Unpack a FIASCO image
-f, --flash Load and flash all supplied images
-l, --load Only load all supplied images
-b, --boot[=ARG] Boot the kernel with optional cmdline
-R, --reboot Reboot the board (e.g. after flashing NOLO)
-i, --read-device-id Print out the device type
-S, --serial-port=ARG Serial port used for cold flashing or "usb"
-I, --init-port Only initialize the serial port
-c, --cold-flash "Cold flash" the device
-h, --hw-revision=ARG Specify product code and HW revision
--enable-rd-mode Enable R&D mode on the device
--disable-rd-mode Disable R&D mode on the device
--set-rd-flags[=ARG] Set R&D mode flags on the device
--clear-rd-flags[=ARG] Clear R&D mode flags on the device
--query-rd-mode Query the device R&D mode status and flags
--set-hw-revision[=ARG] Set HW revision override on device
--flash-only=ARG Flash only certain components
-U, --usb-device=ARG Specify USB device to use (bus:device address)
Image 'mmc', size 255947 kB
Version RX-51_2009SE_10.2010.13-2.VANILLA
USB device found found at bus bus-0, device address \\.\libusb0-0005--0x0421-0x0
105.
Found device RX-51, hardware revision 2204
NOLO version 1.4.14
Version of 'sw-release': RX-51_2009SE_3.2010.02-8_PR_MR0
Booting device into flash mode.
Suitable USB device not found, waiting.
USB device found found at bus bus-0, device address \\.\libusb0-0005--0x0421-0x0
1c8.
Raw data transfer EP found at EP2.
Image(s) flashed successfully in 29.546 s (8662 kB/s)!
Sounds to me like you need to take it to Nokia Care.
There is little more to do other than flashing the device, and, since it was done correctly, that's that.
Sounds like the SoC is shot, but I can't tell like that. Solid orange is good (if it's orange. If it's red, it's bad). Use a multimeter to check battery - any voltage above 3.6 is OK in the sense that battery is still there and kicking. 4.2 is full, 3.6 is empty.
Don't think it's the battery, if it were it would die not get stuck. I had something similar to your issue in the sense of it getting stuck about where yours was, but I solved that via flashing.
If you connect the device to USB while off, does it still power up and act like an USB stick? Did you try to boot it without SIM and SD?
ETA: I remember someone was talking about publishing an image for N900 EN with Backupmenu and Bootmenu already in - that could allow you to power up N900 with kbd open and check the filesystem - maybe determine if the rootfs chip is shot (this could be it - flashing doesn't skip bad sectors and a bad on rootfs would give you similar symptoms).
Thanks for the info ndi
I would take it to nokia centre.
But i think it is out of warranty. I bot it over a year ago from ebay (used).with no proof of sale:/
Every single flash is done without SIM and SD card
When i connect it to USB in flash mode i get the nokia logo with backlight and the USB icon in top right (the backlight is interesting).
Not sure what u mean acting like USB stick but when i plug it in to USB like in wall charger it turns on with back light and keyboard light from right and left no middle (the light on the right of keyboard is brighter then left) and then Nokia logo for 30 s and then that same again. But when i flash it with second image (vanilla) in 1 moment it goes to boot and i see the 5 dots and the they stop on the second from left, and then the vanilla starts flashing, so the boot sector should be ok.
Also when i put the battery in (phone is swithed off) the screen lashes and the keyboard has back light in the same pattern as above and the left side flickers sometimes + when i short press the power button the screen gets backlight.
I also noticed last night, that when i plug in the wall charger with the battery out the orange led flashes once with the right side of keyboard and screen for like fracture of a second. So that possibly says that something is fryed on the motherboard?
The bad root fs could also explain it?
Unfortunatly i havent got the meter to check the battery, but i got the charger today and im in the middle of charging, but still w8ing for the seperate batery.
Also got an info on other forum that flashing with ATF BOX could help buti dont thinks so as the flasher flashes correctly.
