hi
I have such issue: after flashing openmode kernel: when I try to set security code I always get "wrong code" message.
and second thing from time to time it looses password to accounts
getting back to stock kernel solves the problem. I've red that openmode kernel uses different crypto method. should I do sth before flashing openmode kernel?
(I've tried to flash on clean system)
hi
I have such issue after flashing openmode kernel: when I try to set security code I always get "wrong code" message.
and second thing from time to time it looses password to accounts
getting back to stock kernel solves the problem. I've red that openmode kernel uses different crypto method. should I do sth before flashing openmode kernel?
(I've tried to flash on clean system)
Its not a bug, in open mode CAL area is locked, so you security code feature is disabled. You currently cannot use open mode if you want to have working security code.
Hopefully someone releases alternative lockcode solution for open mode someday.
oh gawd did you read thro' about open mode even once???
it clearly says once you've installed open mode delete all your accounts and re-add them or delete the following 3folders (which would do the same thing):
oh gawd did you read thro' about open mode even once???
it clearly says once you've installed open mode delete all your accounts and re-add them or delete the following 3folders (which would do the same thing):
and what for I was suppose to delete those folders if I flashed "clean" system /with emmc/ then flashed modified kernel and at the end set up accounts?
