I must say I do not regret having raised my hand when you told about the first 5 OHOLED 40 € each.
Too bad the Sculpteo parts have a minimal thickness of 0.5 mm (even though total thickness of the OH remains unchanged), this may trap more dust and look a little bit less good. But there are constraints and that OH will be awesome anyway! Impressive work!
The last version is almost perfect! Seriously considering this.
Just one question: Is the 'TOHOLED' text and your logo going to be on the final model as well?
I think it would be cool to have it on the pcb as seen on the pictures, but I like to have the back of my phone as clean as possible.
Just one question: Is the 'TOHOLED' text and your logo going to be on the final model as well?
Next version will have these on inside. It has been easier to check that the print starts ok with some details instead of just a large flat area. (first layer is sometimes tricky)
ATM these are negative, so they make the plastic thin and fragile on those places.
I could easily push my finger through the 'derp' (then it looks like this )
color is good question ... check sculpteo polished plastic selection
White, black, red, green, blue or yellow, they say. Black is not an option to me. I'm sort of used to Jolla meaning phone with dual colors.
Will it be possible to change the colour of numbers/text on the OHOLED.(?) I think I'll go with yellow plastics, if the blue OLED text in your pics can be changed. (Assuming that you'll take more orders later)
)