Hey, I've been meaning to strenghten the usb ports on my two N900s before the ports fall off, but I was wondering, what kind of soldering iron do i need?
Would a cheap 60w one with thin tip suffice? For solder wire I already plan on using 0.3mm tin/lead wire.
Any suggestion would be welcome. I use soldering irons years ago but never for a job as small as this, so I'm not sure what would do.
have you filed your micro usb b fangs down yet?
I think I am going an epoxy route. no heat to damage anything and no hot solder where I dont want it though can probably get epoxy where you dont want it, shouldnt make a short circuit though if it does.
have you filed your micro usb b fangs down yet?
I think I am going an epoxy route. no heat to damage anything and no hot solder where I dont want it though can probably get epoxy where you dont want it, shouldnt make a short circuit though if it does.
I think I was one of the first people that epoxied the port in place. That particular N900 is long sold, so I cannot verify how long it lasted. However my current N900 was used for 4 years with a regular usb cable and a non modified motherboard. I soldered AND epoxied the port in place, and it's been working perfectly for another year since.
I think soldering is a stronger bond, preventing micro cracks. The epoxy alone might not be enough if you don't prep the surface properly and use cheap epoxy. If you have the skill and tools, go for both.
