Reply
Thread Tools
Posts: 10 | Thanked: 0 times | Joined on Feb 2008
#1
hey, does anyone else experience this? the stand for the n800, even on a flat surface, when it's in the most reclined position wobbles a little when i press on it to one side, as if one side is a little bit more elevated than the other. just wondering - thanks .
 
Benson's Avatar
Posts: 4,930 | Thanked: 2,272 times | Joined on Oct 2007
#2
Yes, mine does that too. As a machinist and mechanical engineer, I can tell you it would add significantly to the cost to make the two edges of the recess (one on each end) that limit the stand's travel have any precision. And there'd really be no point.

If it bothers you, though, you can fix it by filing/JBwelding the side that hits first/doesn't hit first.
 
Reply

Thread Tools

 
Forum Jump


All times are GMT. The time now is 03:44.