Would it be feasible via 3D printing to make an "other half" that had a Mobile HotSpot device incorporated into it. Then you could make calls and have reasonable data speeds. Can parts from HotSpot device be cannibalized so as to not make the "other half" too big? Also, would this fry your brain over time? Seriously, would prolonged exposure to WiFi source at close distances be hazardous to health?
Would it be feasible via 3D printing to make an "other half" that had a Mobile HotSpot device incorporated into it. Then you could make calls and have reasonable data speeds. Can parts from HotSpot device be cannibalized so as to not make the "other half" too big? Also, would this fry your brain over time? Seriously, would prolonged exposure to WiFi source at close distances be hazardous to health?
Interesting question, really
I'd assume that if the output power of the WLAN device is attenuated enough there would be no health hazards whatsoever. As the parts are physically next to each other the transmission power needed would be small indeed (a quick estimate; less than 1dBm would be more than enough...). That would be easy to build into the hotspot part built in the OH, but how could you make sure that the output of the Jolla device would be low enough?
However, the power output of the 3G part of the device is on the range of 20dBm...27dBm, while WLAN is rated at around 15dbm so I'd suppose there's no immediate hazards even when the WLAN is operating at full output
