jamiepda | # 1 | 2009-02-06, 01:23 | Report

Hi All-

I just got my n810, so far so good. Still playing around with it, and need to get a bigger card for it.

I have a snag with my wireless setup, however.

I have two access points in my house- and older Apple "airport express", which supports B & G, and an apple "Time Capsule", which supports N, B, and G (the time capsule is basically an airport extreme with a harddrive built in).

When I connect to the express, all works fine. When I connect to the TimeCapsule, it works for a short time, then stops. The little indicator at the top shows that I am "connected", with reasonable signal, but I can't get anywhere (no http, no ping, etc).

Is there something that I can try to resolve this?

thanks

Thesandlord | # 2 | 2009-02-06, 01:49 | Report

Disable N, might help. How much time is short?

jamiepda | # 3 | 2009-02-06, 11:32 | Report

Short is anywhere from a minute of idle time, to a few minutes.

Heck, it might even be immediate sometimes.

Disconnecting then reconnecting helps, but it just stops again.

stangri | # 4 | 2009-02-06, 19:54 | Report

I'm thinking disabling power savings in advanced settings of wifi connection on NIT should help. It's been discussed before if you're into searching.

allnameswereout | # 5 | 2009-02-10, 11:46 | Report

Check the logs of your AP.