dooint: Well, that is indeed strange. Sorry for asking what may be the most obvious stuff, but I hope you KEEP 'u' key pressed (for a while) as you insert the usb cable?
You start the flasher before you press 'u' and insert usb cable right?
And, could there be something with your PC side drivers for the flasher? Maybe install that flasher again or on a different machine?
Is someone else experiencing this incapability to flash this way?
Larswad sure i press u before after and so on, the easy way you can install nokia software updater but it don`t find device to, at moment biggest problem is my battery level atmost 0 then device get little bit energy it starts and stop battery charging
dooint: Well, that is indeed strange. Sorry for asking what may be the most obvious stuff, but I hope you KEEP 'u' key pressed (for a while) as you insert the usb cable?
You start the flasher before you press 'u' and insert usb cable right?
And, could there be something with your PC side drivers for the flasher? Maybe install that flasher again or on a different machine?
Is someone else experiencing this incapability to flash this way?
Haha, yes. I press u until my thumb goes numb. Good idea, though. I've been doing this on my laptop. I'll try it on my desktop.
Booting kernel from legacy image at 80538e58
Image name: kernel-power
Image type: ARM linux Kernel image (uncompressed)
Data size: 1793624 Bytes 1.7 MiB
Load address: 80008000
Ebtry Point 80008000
Verufying Checksum ... OK
Load Kernel image OK
Using existing atags at 0x80000100
Staring kernel ...
and here goes nothing
Can someone confirm taht the camera will crash while starting with the new release? i cant fire up the camera as long as the enhanced power kernel is installed... is there a way to go back to a previous version?
