neotalk | # 531 | 2011-02-22, 11:20 | Report

Many Thanks...i have been trying for days to fathom this out.
:->

dashti | # 532 | 2011-02-27, 13:20 | Report

aim using it coool

colla84 | # 533 | 2011-02-28, 09:12 | Report

dunno why dont work on my n900... i do all steps correctly.

I do , enabled injection, enabled monitor, monitor scan wpa, click on linea the first, wait for 10,000 + beacons but the button for start packet injector isnt up... i think need to reinstall all :|

Excesv | # 534 | 2011-02-28, 11:04 | Report

sorry how would i go about uninstalling this?.. mainly the menu logo as i cant get it to work for me?.. thanks

pusak gaoq | # 535 | 2011-02-28, 13:35 | Report

in order to start packet injector you must remember this...
look at the WEP/WPA that you wanna cracked first....see at the bottom of the list...if you can see the MAC address of the WEP/WPA then you can try cracked it but if the WEP/WPA didn't show any MAC address on it then you cannot even try to packet inject it...

colla84 | # 536 | 2011-02-28, 13:57 | Report

the mac address always show me

pusak gaoq | # 537 | 2011-02-28, 14:05 | Report

are you sure????
cause after you have scan it there will be a few WEP/WPA on the list...try clicking a few of them n see if the MAC address change after you have selected other connection to another connection......
if it does then you can try cracking it but if the MAC address didn't changes then you wont be able to cracked it.....

colla84 | # 538 | 2011-02-28, 18:00 | Report

mac address change always if i chose others connection, but the problem is always the same start packet Injection ins't up ^^ after 8,000 + beacons, if i found an application for do a video i show you my problem!

edit: this time i do these steps:
Monitor enabled, Scan, select connection, enable injection, start capture and cant push start packet ijection


Thanks for help ^^

---

Last edited by colla84; 2011-02-28 at 18:11.

pusak gaoq | # 539 | 2011-02-28, 18:12 | Report

you don't need to wait until you have 5,000+beacon....
just press "start packet capture" first & waits until x-term popup...
after a few second the beacon start been collected go back to fAircrack menu (without closing the x-term) then press "authenticate" button...then enother x-term will popup giving you a list trying to authenticating the connection...
then go back to fAircrack menu again (without closing the 2nd x-term) n press "start package injection"...another x-term will popup...this time watch the x-term(fAircrack do it job)....

now some people can start package injection with have to authenticating with the connection while some other have to...
you can try both method & see which one is best for you...

FRuMMaGe | # 540 | 2011-02-28, 18:21 | Report

Everyone experiencing problems, what firmware are you running on?

I'm on PR1.3