FYI The mappings are: 24=q/1 ... 33=p/0 and 40=d/# You don't have to worry about the modifiers as the dialler converts codes to valid DTMF values. For instance:
Originally Posted by
./injectkey 33 26 ... 40
dials "03...#" very much faster than the dbus calls.
I haven't figured out how to close the keypad on the screen yet but that's all that's missing to make this a quite usable, if ugly, hack.
FYI The mappings are: 24=q/1 ... 33=p/0 and 40=d/# You don't have to worry about the modifiers as the dialler converts codes to valid DTMF values. For instance:
dials "03...#" very much faster than the dbus calls.
I haven't figured out how to close the keypad on the screen yet but that's all that's missing to make this a quite usable, if ugly, hack.
It does look ugly but let me try to merge this with qt code.
how do you generally dial/enter the international number after calling your calling card number? Some cards ask for "<country code> phone number", some ask for "011<country code>phone number".
So depending on your calling card system's requirement, you need to choose the number format as the "format required for dtmf tone".
The setting "delay before sending dtmf" can be left as 1 for most cases. Increasing this number is required only if the calling card system makes you wait for a long time before entering the phone number.
how can i use calling card in my n900 nokia. I cannot install any dialing software
Hi, I'm new here and with Maemo on my N900. I like the application Vicar very much and it's exactly what I'm looking for, but I can't get it running well.
Perhaps this is important: The system is up to date, but I'm using kernel 2.6.28.10-power47
I installed Vicar with the programm manager. The phone numbers are stored in the format as e.g. +49 (170) 27684
I'm using smslisto.com as the card providor.
My setup for "Default profile":
------------------------
Calling card number: <telephone number from providor>
Format required for DTMF tone: 00<Country code><Area code><Phone number>
DTMF tone prefix: p
DTMF tone suffix: #
------------------------
I don't defined another profile, so I can read in Vicar's main window:
No profile found, then call via 911323001
If in adressbook I click "Call via Vicar" this message comes up:
Vicar: +49 (170) 27684 is not a valid number
and nothing happens.
What is my mistake, how can I setup Vicar to dial numbers from my adressbook by phone cards?
