|
|
2008-02-25
, 00:58
|
|
Posts: 364 |
Thanked: 54 times |
Joined on Feb 2008
|
#2
|

|
|
2008-02-25
, 02:19
|
|
|
Posts: 868 |
Thanked: 474 times |
Joined on Oct 2007
@ Capital District, NY, USA
|
#3
|
|
|
2008-02-25
, 02:49
|
|
Posts: 364 |
Thanked: 54 times |
Joined on Feb 2008
|
#4
|
|
|
2008-02-25
, 02:52
|
|
|
Posts: 868 |
Thanked: 474 times |
Joined on Oct 2007
@ Capital District, NY, USA
|
#5
|
|
|
2008-02-25
, 03:00
|
|
Posts: 364 |
Thanked: 54 times |
Joined on Feb 2008
|
#6
|
|
|
2008-02-25
, 03:19
|
|
Posts: 364 |
Thanked: 54 times |
Joined on Feb 2008
|
#7
|

|
|
2008-04-18
, 05:02
|
|
Posts: 6 |
Thanked: 1 time |
Joined on Apr 2008
|
#8
|
http://www.internettablettalk.com/fo...ad.php?t=17092
But my answers was too long and too involved and off topic so I moved it here...hope that is cool?
Anyway, here's how I roll on the road:
To power the router you need 5v so I need all four batteries to get a total output of just over 5v, about 5.2v measured at the end of the cable. I debated over the Tekkeon MP3450 too as it would easily power the router, the NIT combines pretty much all day long and then some if need be...but I opted for the MP1550 for now. Smaller by far and lighter.
No matter what power supply you get you want to be sure it has a voltage regulator. These Cradlepoints can be sensitive if too much current is supplied and will just sit there and smoke...so voltage regulator = good, non-voltage regulated=bad, very bad...
You cannot power the router AND use the EVDO modem via the USB port on the router at the same time...of obvious reasons, one port = one use/device at a time. You can however make or buy a cable to power the router via a USB port on your computer.
For the connection from the battery pack to the router (or router to computer's USB port) I made my own from a USB cable and a size "L" size tip, wired for a "tip" positive. Cost me nothing because I had the parts and just made a few snips here and there a bit of solder and some heat-shrink and viola a custom cable in like 15mins. You can see the cable in the pic. You can, of course, order the correct adapter for the MP1550 but, like a doofus I forgot to do so when I ordered the battery pack and, well, of the like 8 adapters it comes with none were size "L"...daaaang it!@@
I did not show it but for now I have a small Timbuktu accessory bag with a clear front to see what is in the bag. I am eventually going to get another Tom Bihn Buzz bag. I have to say it is the most useful and in obtrusive backpack style bag I ever owned. Sadly, I bought it for my better half and she is never gonna give it up...seriously it replaced her purses when we are just kicking around. The design of the bag is such that you can jusr slide it around to your chest and the zippers are on top and you can access anything in the bag, zip up when done and slide it back around....very nice for light OTG use. I also have a Tom Bihn Super Ego that carries my 17" laptop and I can slide the small utility bag in there easily.
One of the nice parts of this setup is I can trun on the router/modem combo and slip it into an outer pocket in the backpack or even as I said in my back pocket (just don't sit on it or crunch!! d'oh!!)
As for Skype I find it best to be running no other apps on the NIT and it works fine...as long as the MBB connection is stable. Only a couple times was it bad to the point of useless...I use it everywhere I go and would guess it's 99% just fine w/o any cut-outs or drops. But, we are in a great coverage area for EVDO as well as I have a nice solid & stable DSL connection at home.
We also save a fortune with SkypeIn numbers as we have places in Seattle, WA & down here near Santa Barbara, CA. Plus her dad lives in Spokane...I have local numbers in both places that cost just $24/yr each...we save that in a single week when she is up there.
whew....ok, I done now...shorter posts the rest of the week!
Oh, heck one last thing here is a diagram of the whole setup in summary: