Reply
Thread Tools
Posts: 35 | Thanked: 4 times | Joined on Nov 2007
#1
Hi All-

I just got my n810, so far so good. Still playing around with it, and need to get a bigger card for it.

I have a snag with my wireless setup, however.

I have two access points in my house- and older Apple "airport express", which supports B & G, and an apple "Time Capsule", which supports N, B, and G (the time capsule is basically an airport extreme with a harddrive built in).

When I connect to the express, all works fine. When I connect to the TimeCapsule, it works for a short time, then stops. The little indicator at the top shows that I am "connected", with reasonable signal, but I can't get anywhere (no http, no ping, etc).

Is there something that I can try to resolve this?

thanks
 
Posts: 1,213 | Thanked: 356 times | Joined on Jan 2008 @ California and Virginia
#2
Disable N, might help. How much time is short?
__________________
----------------------------------------------------

www.ezschool.com - The best online educational experience.
 
Posts: 35 | Thanked: 4 times | Joined on Nov 2007
#3
Short is anywhere from a minute of idle time, to a few minutes.

Heck, it might even be immediate sometimes.

Disconnecting then reconnecting helps, but it just stops again.
 
stangri's Avatar
Posts: 145 | Thanked: 18 times | Joined on Aug 2008 @ Vancouver, BC
#4
I'm thinking disabling power savings in advanced settings of wifi connection on NIT should help. It's been discussed before if you're into searching.
 
allnameswereout's Avatar
Posts: 3,397 | Thanked: 1,212 times | Joined on Jul 2008 @ Netherlands
#5
Check the logs of your AP.
__________________
Goosfraba! All text written by allnameswereout is public domain unless stated otherwise. Thank you for sharing your output!
 
Reply


 
Forum Jump


All times are GMT. The time now is 10:53.