i flashed to ubiboot to restore my data after screen broke, now i fixed the screen, but my battery is 0%, when i try to charge through usb, my n9 starts after few seconds with:
Welcome to Ubiboot ver. 0.3.3
(Boot loader is based on Moslo ver. 0.0.13.1)
Try 1 (0)
Partitions exported successfully via USB
Configured 192.168.2.15 on USB
Starting DHCP server, offering 192.168.2.100
Starting Telnet server
Starting SSH server
stays like this for a few more seconds then shuts off !
any idea how i can re-charge it?
Did you try to force the charging mode with flasher?
When battery is totally flat the device cannot even start charging as it requires it to start up a little bit to run the charging algorithm.
Start flasher like you would flash the device, and it should say that charge is not enough to fo it, as it is requires to have 11% charge for flashing.
Then the flasher starts to force-charge it, and it will slowly show the charge rising, percent by percent. When it reaches 9% or 10% or so, before it is enough to start flashing, disconnect it and plug to wall charger to charge it to full
yes i tried, but the flasher doesn't see the phone!
Strange that.
What OS are you using, Linux or Windows?
Have you flashed it before with the same computer, same cable?
Are you sure the device is totally OFF when you connect the flasher?
(if you press the power button very shortly, the power LED should blink once if it is off)
- so I need to make total flash and then found out!!?
: